Medication Administration Errors Result in Exceeding 5% Medication Error Rate
Penalty
Summary
The facility failed to maintain a medication error rate below 5%, with surveyors identifying 2 errors in 28 medication administration opportunities, resulting in a 7.14% error rate. For one resident with diabetes mellitus who was cognitively intact and received insulin injections daily, the physician’s order directed administration of insulin aspart 23 units SQ with meals. During observation of a medication pass, an LPN removed the insulin aspart pen from the cart, dialed the pen directly to 23 units, attached the needle, and administered the dose without priming the pen. The LPN confirmed she did not prime the pen and acknowledged that her usual practice would be to prime the pen, then dial the required dose, then place the needle on the pen. Manufacturer instructions for the KwikPen specified that the pen must be primed before each injection by selecting 2 units, holding the pen needle-up, tapping to move air bubbles, and pushing the dose knob until insulin is seen at the needle tip before dialing the prescribed dose. In a separate incident, another resident with Crohn’s disease, diverticulosis, constipation, severe cognitive impairment, and frequent bowel incontinence had a physician’s order for MiraLAX powder 17 g PO once daily. During an observed medication administration, an LPN measured the MiraLAX powder by filling the product cap only to just under the very bottom line inside the lid, then poured this amount into water for administration. When asked to read the product instructions, the LPN reviewed the MiraLAX container, which stated that the bottle cap is a measuring cup designed to contain 17 g when filled to the top rim. The LPN confirmed that the MiraLAX had not been measured according to the manufacturer’s instructions. These two observed medication administration errors formed the basis of the cited deficiency under the referenced complaint investigation.
We Help Long-Term Care Teams Stay Survey-Ready
We process and analyze inspection reports and plan of correction using AI to extract insights and trends so providers can improve care quality and stay ahead of compliance risks.